To properly sheathe wall surfaces with wood panels, you need to follow the tips and tricks. For more details on how to install wood panels, read below. Self-paneling with wood panels is not such a difficult job. Compared to finishing carpentry work, paneling does not take much time, does not require haste, heaps of nerves. If you want to get it right, then you need a steady hand, correct measurements, and a good set of tools. It is better to hire an assistant for such work. Although the work is not dusty, in order to keep the 4x8 wooden panel exactly in one place, you will need the help of another person.
There are several ways to do this. To do this, you will need to learn a few tips from the professionals.
The first step is to take measurements. Measurements are best done twice. Once again, check whether you did everything correctly. Especially when you are working with expensive or heavy bespoke panels. To do this, you will need to measure the entire room that you will be sheathing. The length of the walls and their height, as well as the dimensions of the windows and doors that meet in the room. You don't have to worry about junction boxes or other parts that will come across in your room.
The next step is to ventilate the wood panels. For those in a hurry, this procedure should not be neglected. To avoid chips, cracks and other minor defects, the wooden panels should be ventilated. This procedure will provide the best finish to your panels. Do not stack them one on top of the other. This method is suitable if only there is space between them so that the air can circulate normally. It is best to install the panels vertically along the walls. Each wood panel separately. Leaving them to ventilate is best for 48 hours.
An important fact is the creation of a smooth surface in the place where the paneling will be carried out. It is best to install the wood panel on a drywall or plywood surface. If you decide to just nail your panels to the surface, then don't expect a good work result. The surface for the cladding must be smooth, otherwise you cannot avoid cracks, bumps and other defects in the cladding. If your wall or any other surface requires repair, that is, there are areas where you need to replace drywall or re-plaster the wall, it is better to do this before you start sheathing the walls with wooden panels. The wood panel is not simply attached to the wall. To do this, you first need to install special rails. The location of the rails depends on how the panels will be attached - horizontally or vertically. You will need to use thin planks or shingles to achieve the most even effect. You can also use anchors in masonry or special glue.
The main stage of cladding is the installation of the first panel. A correctly installed first piece of wood will serve as a template for installing further ones.
Read the technical instructions for your specific panel. If the manufacturer recommends using nails, make sure you are using the correct nails or other materials such as wood panel glue.
